Tag: stamping parts
-
Common problems of sheet metal processing stamping parts
The sheet metal stamping process converts hot-rolled or cold-rolled steel plates into the shape needed to make your parts. This technology allows a large number of parts to be produced at the same time, but it can also cause about 15% of raw materials to become waste. The equipment used in this method requires less […]
-
Common problems and causes of sheet metal processing and stamping parts processing
Common problems and causes of sheet metal processing and stamping parts processing: 1 burr: the excess material is not completely left during stamping or corner cutting, and burr appears under the steel plate section. When the burr height is greater than 0.2mm according to the section, the iron powder will damage the die and produce […]
-
Causes of burr production
Causes of burr production in hardware stamping parts(Sheet metal parts) 1.The first possible reason is that the knife edge is blunt. Burr will be produced when the cutting edge is worn, blunt or gnawed. The factors affecting the blunt edge are: 1)It is not lubricated in time during operation, resulting in rapid wear; 2)Didn’t grind […]